Now that you've set up your Hub, let's connect to your monitor.
If you haven't set up your hub, click the link to find step-by-step instructions.
Here's what we'll go through:
Open the monitor
Twist the lid and pull up until the monitor clicks in place. It should be able to stand up like shown. Note that there are two sides of the monitor. One side is for the battery, and the other side is for the cartridge.
Battery side
Cartridge side
Install the battery in the Monitor
Make sure that the battery has been charging for at least 24 hours.
Insert the battery into the monitor as shown. Make sure that the gold lines match up, then insert the battery bottom first. The battery should click into place. You will see a blue LED light on the monitor, just above where the battery was placed.
Locate the pairing buttons
There are two pairing buttons: one on the hub and one on the monitor. Both pairing buttons will have a pairing icon. Locate both pairing buttons, but do not press them yet.
Hub Pairing Button: Open the hub by pressing down on the dent on the top of the hub (the same way you opened it to charge the battery). You will see the pairing button right below the battery insert.
Monitor Pairing Button: The monitor pairing button will be located right above where the battery is placed, near the LED.
Pair hub and monitor
Now that you've found both pairing buttons, hold down both buttons at the same time until they both rapidly blink, then let go. Both LED lights will turn solid blue.
Troubleshooting:
My LED lights are not turning blue: If one or more LED lights are not blue, make sure there is not a battery charging in the hub and try re-pairing both devices by holding down the pairing buttons again.
Congratulations! Your monitor and hub are successfully paired. The app should now take you to a new screen to install the cartridge.